Janome MyStyle 100 - SECTION 2. GETTING READY TO SEW; Connecting the Power Supply

8
r
t
q
e
w
Connecting the Power Supply
z Turn the power switch off.
x Insert the machine plug into the machine
socket.
c Insert the power supply plug into the wall
outlet.
v Turn the power switch on.
q Power switch
w Machine plug
e Machine socket
r Power supply plug
t Wall outlet
NOTE:
Before connecting to the power supply, make
sure the voltage shown on the machine
conforms to your electrical power.
WARNING:
While in operation, always keep your eyes on
the sewing area, and do not touch any moving
parts such as the thread take-up lever,
handwheel or needle.
Always turn off the power switch and unplug
from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control,
otherwise the machine will run intermittently.
SECTION 2. GETTING READY TO SEW
Operating Instructions:
The symbol "O" of a switch indicates the "off"
position of a switch.
For an appliance with a polarized plug (one blade
wider than the other):
To reduce the risk of electrical shock, this plug is
intended to fit in a polarized outlet only one way.
If it does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not
modify the plug in any way.
The foot controller Model YC-482J or TJC-150 is
used with the sewing machine Model My Style
100 (USA market only).
Janome MyStyle 100 Sewing Machine Instruciton Manual
www.janomeflyer.com
MyStyle 100 Owners Manual/ User Guide