Janome TM30 - Special Stitches: Buttonholes, Zippers, Hems

29
Memory Buttonhole
q Stitch pattern: 17
w Thread tension dial: 1 to 4
e Presser foot: Sliding buttonhole foot
4
w eq
z
z Mark the buttonhole position on the fabric.
Place the fabric under the foot with the buttonhole
mark running toward you.
Draw the needle thread to the left through the hole of
the foot.
q Buttonhole mark
w Start mark
e Bobbin thread
r Needle thread
e q
r
x
w
c
x Turn the handwheel toward you to lower the needle at
the start mark.
c Push the buttonhole foot to the rear until it stops.
Make sure there is no gap between the slider and the
stopper, aligning marks on the stopper and the slider.
Lower the presser foot lifter.
e Bobbin thread
r Needle thread
t Stopper
y Slider
u No gap
i Marks
o Presser foot lifter
v v Start sewing while pulling the needle thread lightly
to the left. After a few stitches, free the thread and
continue sewing.
o
NOTE:
Apply an interfacing to stretch or ne fabrics.
u
y
t
i
NOTE:
The scale on the buttonhole foot is engraved in 0.5
centimeters.