6.7. LIFT TIG mode parameter setting
In the LIFT TIG welding mode, rotate the adjusting knob to set the current parameter.
6.8. Protection indicators
When the overheat indicator is on, this indicates that the welder has overheated and
current ceases. When the welder cools, the indicator will go out.
When the overcurrent indicator is on, this indicates that the welder has entered the
overcurrent protection mode and the welder stops producing current
6.9. VRD (Voltage reduction device) function indications
1) When the VRD function is not enabled, the VRD indicator light is off.
2) When the VRD function is enabled, the VRD indicator displays green and no welding
is performed, indicating that the VRD function is normal.
3) When the VRD function is enabled and no welding is performed the VRD indicator light
displays red , indicating that the VRD function is abnormal.
4) When the VRD function is enabled the VRD indicator is not on during welding.
6.10. Barcode display
Before welding, press the welding mode key and parameter adjustment knob for 3S at
the same time the meter displays the machine barcode.
Pressing any key or rotating the encoder you will find that the machine will immediately exit
the barcode display. If you do not perform any operation on the panel, the barcode display
automatically stops after 20s.
6.11. Restore factory settings
1) Before welding, press the welding mode key for 5 seconds to return to factory
defaults.
2) After pressing and holding for 1 second, the display window starts to count down from 3,
when the countdown ends, and the factory settings are restored. If the button is released
before the countdown ends the factory will not take place.
3) Factory defaults: MMA: Manual state, current: 80A; TIG current: 80A.
To Next Page
Loading...
