After the remote controller is successfully paired, press the remote control function
button on the panel or the pairing button of the wireless remote controller for 2
seconds, and the wireless connection of the remote controller will be disconnected. After
disconnecting the display window of the welder displays the character "FAL", and the green
indicator of the wireless receiver module will be constantly on.
7. Welding function operation
Warning! Before turning on the power supply make sure that the equipment
is disconnected to the output. Otherwise, an unexpected arc may be started
when the power is turned on. This can cause damage to the work piece and
to personnel.
Warning! Be sure to wear appropriate protective equipment during welding
or cutting operation. Arcs, spatter, smoke, and high temperatures produced
in the process may cause injury to personnel.
Warning! After the power supply is turned off, the output voltage of the
machine may continue for a period and then drop slowly. Please do not
touch the conductive part of the output before the panel is extinguished.
7.1. MMA operation
7.1.1 Turn on the power switch.
The power switch is located at the rear panel of the machine, set it in the "ON" position, then
the panel indicator is on, the fan starts to rotate, and the welder starts to work normally.
NOTE! Some models are equipped with the smart fan function. When the power
supply is turned on for a period before welding or cutting, the fan will automatically
stop running. It will run automatically when welding or cutting begins.
7.1.2 Select MMA mode
To Next Page
Loading...
