Jasic ARC200PFC - LIFT TIG Welding Operation

Page 29
7.2. LIFT TIG operation
7.2.1 Turn on the power switch.
(Same as 7.1.1)
7.2.2 Select TIG welding mode.
(LIFT TIG mode)
7.2.3 Set the welding parameters
In the LIFT TIG mode, set the welding current parameters using the knob.
Choose the appropriate welding current, tungsten electrode, and shielding gas flow based
on the welding requirements. As a guide please refer to the following data.
Stainless steel plate-selection of parameters for manual TIG arc welding
Tungsten
electrode
diameter
(mm)
Thickness of
stainless steel
plate (mm)
Maximum current
(A)
Maximum argon
flow rate (l/min)
1~2
1~3
50
5
50~80
6
2~4
3~6
80~120
7
121~160
8
161~200
9
201~300
10