Jasic MIG SERIES - MIG Welding Installation; Gasless MIG Welding Installation

17
INSTALLATION
MIG welding
Insert the welding torch into the “Euro connector for
torch in MIG” output socket on the front panel of
the machine and ghten it.
Insert the trailing cable plug (A) into the “+” output
terminal of the welding machine, and ghten it
clockwise.
Insert the work return lead cable plug (B) into the
“-” output terminal on the front panel of the
welding machine and ghten it clockwise.
Install the welding wire on the spindle adapter.
Connect the cylinder equipped with the gas
regulator to the gas inlet on the back panel of the
machine with a gas hose.
Ensure that the groove size in the feeding posion
on the drive roll matches the contact p size of the welding torch and the wire size being used.
Release the pressure arm of the wire feeder to thread the wire through the guide tube and into the drive
roll groove and then adjust the pressure arm, ensuring no sliding of the wire. (too much pressure will lead
to wire distoron which will aect wire feeding).
Place the welding mode switch into the MIG posion.
Press the wire inch buon to thread the wire out of the torch through the contact p.
You are now ready to start MIG welding.
Gasless self shielded MIG welding
Insert the welding torch into the “Euro connector for torch in MIG” output socket on the front panel of
the machine and ghten it.
Insert the work return cable plug (C) into the “+”
output terminal of the welding machine and ghten
it clockwise.
Insert the trailing cable plug (D) into the “-” output
terminal on the front panel of the welding machine
and ghten it clockwise.
Install the wire spool on the spindle adapter,
ensuring that the groove size in the feeding
posion on the drive roll matches the contact p
size of the welding torch and the wire size being
used.
Release the pressure arm of the wire feeder to
thread the wire through the guide tube and into the
drive roll groove.
Adjust the pressure arm ensuring no sliding of the
wire (too much pressure will lead to wire distoron which will aect wire feeding).
Place the welding mode switch into the MIG posion.
Press the wire inch buon to thread the wire out of the torch through the contact p.
You are now ready to start gasless MIG welding.
A
B
C
D