15
MULTIFUNCTIONAL DISPLAY WINDOW
The digital displays on the Jasic MIG 200CS have mulple purposes as described below:
A - Current display window
B - Voltage display window
During welding, the current display window displays the praccal welding current value, and the voltage
display window displays the praccal welding voltage value. In standby mode, the windows display as
follows.
* It displays VRD voltage when not turning the voltage control knob, and displays the arc force when
turning the voltage control knob.
System parameters seng
This machine uses a group of welding parameters in common use as default. If the user wants to alter
these parameters, he or she can realize this by altering the system parameters.
The method to alter the system parameter is as follows:
1) Press the 2T/4T switch key on the panel and do not release it. Then, turn on the power switch of the
welding machine.
2) When the display window displays “--- ---“, release the 2T/4T switch key to enter into the system
parameter adjusng interface.
3) Select the welding mode which needs adjusng by turning the welding mode select switch, select the
parameter number through the current control knob, and select the parameter value through the voltage
control knob.
Please refer to the table below for the contents of system parameters.
4) Aer the parameter adjustment is done, press the 2T/4T switch key again to store the system
parameters. Then, the machine enters into standby mode.
Welding Mode Current display window Voltage display window
MMA Preset Current (A) VRD voltage (V) / arc force (A/MS) *
MIG Preset wire feed speed (m/min) Preset voltage (V)
TIG Preset current (A) Downslope me (S)
MMA MIG TIG
P1 Ignion current (A) Crater ll speed (m/min) Inial current (A)
P2 Ignion me (S) Crater ll voltage (V) Pilot arc current (A)
P3 Capacity seng (A) Downslope me (S) Upslope me (S)
P4 Reset to default sengs (0:No; 1:Yes) Pre-ow me (S) Pre-ow me (S)
P5 Post-ow me (S) Post-ow me (S)
To Next Page
Loading...
