Jasic MIG SERIES - Welding Mode Function Switch

14
CONTROLS
Welding mode funcon switch explained Jasic MIG 200CS
The welding mode dial is a 7 posion switch which allows the users to select the dierent weld processes.
1. MMA - MMA welding process posion
2. TIG - Li TIG welding process posion
3. MIG - Standard MIG welding process posion
Synergic MIG Mode:
4. C0² / 0.8 - In this posion you have entered synergic MIG mode for 0.8mm dia welding wire when
being used with C0² gas
5. C0² / 1.0 - In this posion you have entered synergic MIG mode for 1.0mm dia welding wire when
being used with C0² gas
5. 98% Ar + 2% C0² / 0.8 - In this posion you have entered synergic MIG mode for 0.8mm dia welding
wire when being used with gas mixture of 98% Argon and 2% C0²
6. 98% Ar + 2% C0² / 1.0 - In this posion you have entered synergic MIG mode for 1.0mm dia welding
wire when being used with gas mixture of 98% Argon and 2% C0²
The inbuilt synergic control is used in this Jasic MIG 200CS in which the voltage is adjusted in relaon to
the wire feed speed, so when in synergic mode the volts and wire feed speed are linked and altering the
wire feed speed dial will alter each characterisc in-keeping with the welding curve.
Adjusng the voltage dial will trim the voltage but also adjust the wire feed speed accordingly.
3 4 5
2 6
1 7