Why does the electrode holder become very hot on my Jasic TIG200?
If your Jasic Welding System's electrode holder gets very hot, it's likely because the holder's rated current is less than the actual current it's handling. The solution is to replace it with an electrode holder that has a higher rated current capacity.
What to do if Jasic Welding System shows over current LED?
If your Jasic Welding System shows a no-load voltage of “0” and the over current LED is on, it indicates an over current issue or damage to the power components. Try restarting the machine. If the problem continues, it's recommended to contact the service center of your distributor.
What to do if Jasic TIG200 shows under voltage LED?
If your Jasic Welding System is showing a no-load voltage of “0” and the under voltage LED is illuminated, it could be due to low mains voltage or auxiliary power failure. Welding can be resumed once the mains voltage returns to the appropriate level. If the auxiliary power has failed, replace the faulty circuit board.
What to do if Jasic Welding System shows overheating LED?
If your Jasic Welding System shows a no-load voltage of “0” and the overheating LED is on, it means the overheating protection is active. The system should recover automatically once the welding machine has cooled down.
Why no arc can be started on Jasic TIG200 Welding System?
If you're having trouble starting an arc with your Jasic Welding System, make sure that the mains power supply cable is properly connected. Also, check for and resolve any phase failure issues in the mains power supply.
How to fix difficult arc ignition on Jasic TIG200 Welding System?
If you're finding it difficult to ignite the arc on your Jasic Welding System, it might be because the arc ignition current is too low, or the arc starting time is too short. Try increasing the arc ignition current or extending the arc starting time.
What to do if electrode sticking on Jasic TIG200 Welding System?
If the electrode is sticking during welding with your Jasic Welding System, the arc force current might be too low. Try increasing the arc force current.
General| Frequency | 50/60 Hz |
|---|---|
| Protection Class | IP21S |
| Insulation Class | F |
| Duty Cycle | 60% |
| Welding Type | TIG, MMA |
| Rated Output Current | 200A |
To Next Page
