INTRODUCTION
This manual contains all of the information needed for
the proper installation and operation for your Jason
bath. The bath has been designed to give you years of
relaxing trouble-free service, provided the unit is
maintained and operated in accordance with these
instructions.
Thoroughly clean and disinfect the unit as described in
the CLEANING section of the USER MAINTENANCE
INSTRUCTIONS section of this owner’s manual before
its first use and periodically thereafter.
CAUTION: Keep hair, towels and clothing away from
any installed suction fitting whenever the equipment is
ON. Never operate the equipment with the suction
cover off, doing so voids the manufacturer’s warranty—
it is a safety cover designed to eliminate the potential of
hair and body entrapment.
All Jason baths are pre-plumbed at the factory.
WARNING: Before operating, refer to the
instructions at the beginning of this owner’s manual
pertaining to the risk of fire, electric shock or injury
to persons.
Filling and Draining
Close the drain and fill the bath with water to the
desired level (at least two (2) inches (50mm) above the
jet). The inlet temperature should not exceed 104°F
(40°C). When bath is in use, turn the unit OFF before
draining the water. The bath unit and its plumbing are
designed to drain after each use whether used as a
hydrotherapy bath, soaking bath, or just taking a
shower.
NOTE: If the unit fails to operate, check the breaker
panel to ensure that the circuit breaker is on. Check the
GFCI by testing and resetting it. If the unit still fails to
operate, refer to the Trouble Shooting Guide section of
this manual. If the unit still fails to operate and is out of
warranty, contact an authorized service technician for
repair. If the unit is within the warranty period, contact
JASON Technical Services at 800-255-5766. DO NOT
ATTEMPT TO RESOLVE THE PROBLEM.
FEATURES
Jason offers the finest in soaking hydrotherapy baths
but also offers the option for more hydrotherapy choices
with a Jason MicroSilk
®
, AirMasseur
®
or Whirlpool
hydrotherapy unit. Please consult your product
configuration label on the front of this manual to learn
what hydrotherapy experiences await you.
MICROSILK
®
FEATURES
Jason’s MicroSilk hydrotherapy bath supersaturates the
water with negatively charged, oxygen-rich
microbubbles which gives your skin new life. This
results in increased oxygen levels which promotes
healthy skin cell growth, neutralizes free radicals and
encourages healing of scar tissue formation.
MicroSilk
®
Unit
The MicroSilk unit generates the oxygen-rich
microbubbles that fill the bath. MicroSilk units provided
on Jason baths are factory tested when assembled and
again retested after installation on the bath.
MicroSilk
®
Port
A strategically placed MicroSilk port is provided for
complete enjoyment of your bath. The port can also be
used to connect an optional MicroSilk
Shower Wand.
Air ON/OFF Button
The Air On/Off button (air
switch activator) provides
a safe and convenient
method for controlling the
MicroSilk bath. The Air
On/Off button is factory
mounted onto the bath
prior to shipment. To operate, fill the bath to at least
two (2) inches above the jets and press the Air On/Off
button to start or stop the MicroSilk unit. A timer will
automatically stop the unit after 20 minutes of operation
if it is not stopped manually.
To Next Page
Loading...