10-4 SCT
1. Mount the cabinet onto the rail at a 30° angle and slowly lower the outer side
until it is horizontal. If applicable, attach the brace to the underside of the
stove and RV sidewall.
2. Attach the propane system using the “quick coupler” connection (see the
following instructions).
3. Unfold the wind deflectors attached to the lid to prevent the wind from blowing
out the burners.
Wait until the stove is completely cooled, before trying to move or store it.
Attaching the “quick coupler” connection
The “quick coupler” is directly connected to the RV propane system. The “quick-
coupler” connection has a positive shut-off valve as required by code and
standards.
1. Place the “quick coupler handle in the OFF position and push back the
sleeve. The valve handle must be OFF to make the connection.
2. Insert the plug and release the sleeve.
3. Push the plug until the sleeve snaps forward, locking the plug into the socket.
4. Turn the handle ON to allow propane to flow to the drop in stove.
Fig. 10.2 Quick connect coupler
To Next Page
Loading...
Need help?
General
