SECTION 4 TOWING & SET-UP JAYCO CAMPING TRAILERS
4-8
Manual stabilizer jacks (if so equipped)
To lower each jack, insert the jack crank onto the applicable stabilizer jack shaft.
1. To lower each jack, insert the jack crank onto the applicable stabilizer jack
shaft.
2. Turn the crank clockwise to lower each leg until it contacts the ground and
stabilizes the trailer.
To raise each jack, insert the jack crank onto the applicable stabilizer jack shaft
and turn the crank counter-clockwise.
NOTE: The stabilizer jacks must be fully retracted before moving or
towing the RV to prevent stabilizer jack damage.
ENTRANCE DOOR
The entrance door and screen door (if so equipped) is located on the curbside of
the RV. Always hold onto the entrance door when opening or closing it as damage
caused because you failed to do so is not covered by the Towable Limited
Warranty.
KEYS/LOCKS
Several keys are provided when you purchase your RV. Most keys have an
individual key number stamped on the plate. Record these key numbers and keep
the information in safe place. You can order a key blank from your RV dealer to
have duplicate keys made. If you lose the keys, contact your RV dealer or a
locksmith for assistance.
NOTE: Locks on entrance and baggage doors need biannual lubrication using
a light coat of silicone spray. Conditions such as rain, salt, dust and pollution may
increase the maintenance needs.
WARNING
DO NOT USE THE STABILIZER JACKS TO LEVEL THE RV. It is important
to remember that the stabilizer jacks are to be used only for support while
occupying and moving around the RV. They are not designed to support the
CAUTION
Make sure the entrance door is completely closed and locked when traveling.
Locking the door helps prevent it from opening unintentionally.
To Next Page
Loading...
Need help?
General
