SCT HS 14-1
SECONDARY MEANS OF ESCAPE (EXIT WINDOW)
The emergency egress window is designed to allow quick exit from the RV during
an emergency if access to the main entrance door is not available.
• Make sure all occupants know how to open and operate the egress window
before an emergency occurs. (Refer to instructions below)
• When pulling into your campsite, make sure the egress is not blocked by
trees or other obstacles. Make sure the ground below the window is solid and
can be used as an escape path.
The Egress window must be locked during transit
Do not remove the EXIT label from the egress window. (Fig 2.3)
Operating the Emergency Exit Window:
Pull the red handle (Fig 2.2) down to unlock the window.
Slide the window with the screen to the right (Fig 2.1)
NOTE: Continued pressure should be applied to the window until it opens.
CAMPING TRAILER ROOF
Never walk on the roof. The roof of a folding camping trailer is not designed to
accommodate the weight, scratches, dents and punctures that can occur from
walking on the roof.
CAMPING TRAILER SET UP - HARD WALL MODELS ONLY
Step 1
Insure the unit is level. Level the unit front to back using the tongue jack. Leveling
side to side may require blocking under the tires. Lower the stabilizer jacks.
CAUTION
Do not add or install any aftermarket equipment to the roof or store any
items on the roof. Adding equipment or storing items on the roof may result
in damage to the roof and/or roof components.
To Next Page
Loading...
Need help?
General
