12-4
BOOTH DINETTE (IF SO EQUIPPED)
The dinette is designed to seat up to four adults. You can access the dinette
bench storage by removing all the cushions and lifting the bottom seat supports. If
the dinette bottom seat support is screwed shut, it is to protect factory-installed
equipment (do not use that area for storage). To convert back to a booth dinette,
reverse the process.
The booth dinette can be converted into a bed. To convert, remove all the
cushions from the booth dinette. Lift the tabletop, remove the detachable table
legs and place the tabletop on the ledges provided between the booth dinette
benches. Lay the seat back cushions against the back of the booth dinette bench.
Lay the dinette seat bottom cushions in between the seat back cushions. The area
where the cushions meet should be slightly raised.
Push the raised cushion ends down gently. The cushions are designed to fit
snugly. Reverse this process when converting back to the booth dinette.
To Next Page
Loading...
Need help?
General
