14-8 SCT HS
INSTALL VELCRO AT THE STEP: Install the screen from behind the step
(Pic 6a). This allows the step to be used to get in and out of the trailer and still
provide protection from insects. While holding the screen in (Pic 6a) determine the
location for the 2 velcro strips that will attach to the frame under the door.
NOTE: If the screen is in place, the step cannot be retracted.
INSTALL VELCRO ON EDGES OF FRONT WALL (front wall has the door)
Using the supplied roll of Velcro and beginning at one of the sloped edges of the
front wall begin attaching one continuous strip of Velcro from bottom of the sloped
wall (Pic 7) all the way to the peak, over the peak, and down to the bottom of the
other slope (Pic 8). Cut the Velcro at the bottom of the other slope.
This completes the installation of the Velcro strips.
To Next Page
Loading...
