94
plumbing SyStem
Using the Uni-Doc Utility Center:
The following information details the functions of the utility center water valves as displayed
on the valve operation label located on the Utility Center front panel.
“POWER FILL TANK” (Pressurized fresh water source)
1. Connect the fresh water hose to the City Water Connection inlet on the Utility Center.
2. Set the colored valves to POWER FILL TANK setting:
(A) White handle pointing right
(B) Blue handle pointing left
(C) Black handle pointing right
(D) Red handle pointing up
(E) Green handle pointing right
3. Connect the other end of the hose to a pressurized fresh water source (faucet or spigot).
4. Turn pressurized water source ON, the tank should begin lling.
5. When water has reached the desired level, turn the pressurized water source OFF.
6. Disconnect water source from the spigot/faucet rst, then disconnect from the City
Water ll inlet on the utility center.
“SANITIZE” (or Siphon Fill) the Fresh Water Tank via Pump:
A check valve is located inside the City Water Connection inlet on the
Utility Center. NEVER depress the check valve on “CITY WATER
CONNECTION” inlet with pressure in the line. It will cause irreparable
damage to the valve function and the inlet will leak water.
NOTE: Refer to the Sanitizing Plumbing System section before
starting this process.
To Next Page
Loading...
Need help?
General
