Grounding is your personal protection from electrical shock.
Do
not use any adapter, cheater, or extension cord that will break the
continuity of the grounding circuit connected to that third pin.
NEVER
remove the grounding pin
for
convenience of being able to
connect to a non-ground (only 2-prong) receptacle. Check the polarity
of your power source.
SAFETY
WHEN
EMERGENCY
STOPPING
Always carry road flares and/or reflective triangular highway
warning devices to be displayed when necessary.
Pull
off the
roadway
as
far as possible when changing flats or for other
emergency situations. Turn on your vehicular hazard warning
flashers when parked alongside
a
roadway,
if
only for
a
minute or
two.
ADDITIONAL
SAFETY
CONSIDERATHONS
1.
Sanitize the fresh water supply system periodically (see
sanitizing instructions).
2.
Keep
water connection fittings from coming
in
contact with the
ground or drain hose to reduce chance of contamination.
3.
Enlist services of a qualified technician to
fix
gas or electrical
appliances.
4.
Always have a serviceable fire extinguisher placed in an easily
accessible
location.
5.
Please
read
carefully the loading section under Chapter
III
related to
your
respective trailer.
6.
Insure
rhat
tires are
in
good condition and properly inflated.
Watch inflation especially closely
-
under-inflated tires
will
overheat. Overheated tires are a potential hazard as they may
throw rubber and cause a blowout.
7.
Check and tighten wheel lugs regularly (every
50
miles when
new until
200
miles are reached and then check lugs every
500
miles).
8.
Check brakes in a safe area
-
not while traveling a busy
highway.
9.
Use
seat belts (motor homes) at all times.
10.
Disconnect television power cord and antenna lead-in during
local thunderstorms and Iightning activity.
11.
Always solidly block trailer wheels before unhitching.
!2.
Before leaving
a
camp
area with a trailer
in
tow, insure that
the safety pin
or
locking lever
is
seated, breakaway wire
is
attached to tow vehicle, the jack
is
raised so that it cannot
touch the ground, the dolly wheel removed, 110-volt electrical
cord properly stored, safety chains are connected,
and
all
interior
lights
off.
13.
Observe the warning labels attached to your vehicle concerning
L.P.-gas, water, electricity, and loading.
14.
Observe the maintenance chart in Chapter
VTI
related to your
respective
unit.
To Next Page
Loading...
Need help?
General