EasyManuals Logo

Jayco J-Series 1750 User Manual

Jayco J-Series 1750
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
Handle your LP.-tanks
with
care. Note that
when
disconnecting, you
must
turn
the wrench in
a
clockwise
direction because the connection
utilizes left hand threads. When reconnecting, turn wrench counter
clockwise.
When tightening, only "snug-up", avoid over-tightening.
CAUTION:
If
you
have
double
bokths
on
your
R.V.,
use
only one
at
a
time.
Otherwise
the
gas
supply
will
be
drawn
equally
from
both
bottles
until
supply bas
been
totalliy exhausted.
Using
the
one
bottle
until
it
is
empty,
then
using
the
second
bottle
will allow
you
to
fill
the
empty
bottle
at
yyar
convenience without being
tomy
out
of
propme.
USING
THE
AUTOMATIC
CHANGEOVER
REGULATOR
(For
Optional
Double
Bottles
OnEy)
With the automatic changeover regulator, both cylinder valves should
be open. This has a changeover knob with an arrow. The cylinder to
which the arrow points is the "service" cylinder.
The other is the
"reserve" cylinder.
As
long as there
is
fuel in the service cylinder,
an indicator on the
top
of
the regulator will show white.
When
the
service cylinder is empty, the regulator
will
automatically change to
the reserve cylinder and the indicator will change to red.
At this point you should turn
off
the valve of the service cylinder and
turn the changeover knob so that
the
arrow points to the reserve
cylinder, thereby making
it
the "service" cvlinder. The red indicator
will change back to white as soon as you turn the knob. You
may now
discor~nect the empty cylinder and have it refilled.
When
you
reconnect it, it then becomes the "reserve" cylinder.
ELECTRICAL
SYSTEM
81
OPERATION
CONNECTIQN
TO
120
VOLT
AC
Your electrical system of 120-volts
AC
and
12
volts
DC
has been
designed and installed
in
accordance with the safety requirements of
ANSI
Standard
A119.2,
The National Electrical Code or Canadian
Standards Association.
Your new Jayco
is
equipped with a power supply cord to connect to
the campground outlet. The power supply cord ispermanently
pre-wired into the electrical distribution panel of your
R.V.
with an
over-current protector which will trip to the
"OFF"
position should a
short occur.
To prevent accidental shock, insure that the ground pin on the
attachment plug cap
is
intact to the earth ground through the
R.V.
park receptacle. When plugged into the
R.V.
park receptacle
with
no

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jayco J-Series 1750 and is the answer not in the manual?

Jayco J-Series 1750 Specifications

General IconGeneral
BrandJayco
ModelJ-Series 1750
CategoryMotorhomes
LanguageEnglish

Related product manuals