REFRIGERATOR
(Optional
in
some
units)
The refrigerator
in
your Jayco has been designed
by
the
manufacturer to work either on 110-volt electricity or L.P.-gas.
NEVER
attempt to connect or operate the refrigerator on natural gas.
Please follow the operating instructions supplied
by
the manufacturer
of
the refrigerator.
If
the refrigerator
is
not level, the cooling process will be partially or
totally
stopped.
For best cooling, level
the
vehicle and this
should
level the refrigerator. Remember it's the refrigerator that must be
leveled,
so
check the freezer shelf of the refrigerator with a bubble
level.
Installation
of
small levels on the outside of the trailer make
the leveling operation easier.
HOT
WATER
HEATER
(OpBi~nd
in
some
urmits)
Your new coach may be equipped
with
either
a
6-gallon
or
10-gallon
hot
water heater powered
by
L.P.-gas.
If
hot water is used with discretion, there is always
an
ample supply.
With controls similar to those on your home water heater, L.P.-gas
is
autornaticaIly supplied to heat water to
a
desired temperature and
then automatically shut
off,
leaving the pilot burning.
A
regulated
mixture
of
'gas and
air
is
ignited by the pilot to provide
a
flame which
is
directed into
the
heating tube. The heating assembly
is
sealed off
from the
R.V.
interior
and
vented to the outside atmosphere.
If
gas supply to the heater
is
cut off for
any
reason or
if
the
pilot is
blown out,
all
gas supply
is
automatically cut
off
and controls will
have
to
be
reset
to
obtain
pilot
relighting.
CAUTION:
Before
lighting
the
water
heater,
inswe
that
the
fresh
water
system
fs
fitled
with
water
and
the
air
is
purged
&om
the
water
heater
by
opening
all
faucets
mrtiI
water
flows
steadily
from
each.
LIGHTING
THE
WATER
HEATER
1.
Turn gas dial
(1)
to
"OFF"
position.
2.
Wait
5
minutes to ailow gas which
may
have accumulated in
the
burner compartment to escape.
3.
Turn
gas dial (1) to pilot position.
4.
Depress and
hold
reset button
(2)
while lighting pilot burner.
Allow
pilot to burn for 30 seconds before releasing the reset
button.
If
pilot does not
remain
lit, repeat operation aIlowing
longer period
of
time
for
releasing reset button.
5.
Turn gas dial
(I)
to
"ON"
position.
6.
Turn temperature
dial (3)
to
desired position.
7.
To
shut
down heater, turn to
"OFF"
position.
To Next Page
Loading...
Need help?
General
