3
. GENERAL DESCRIPTION 11
E
E
lectrically operated punching. Punches up to 2 mm or 25 sheets of 80gsm paper, in using
the full width, that is to say 330mm.
Binds Wire-O
®
from N° 3 to N° 20 (3/16" to 1" 1/4)
The machine may be plugged into any earthed single phased socket 16A (protection C 30mA).
CAUTION : We disclaim liability if you punch only acetate sheets.
The machine is started by switching on the circuit breaker « 0-1 » by positioning it onto « 1 »
(circuit breaker located at the rear of the machine). When the machine is switched off « 0 » , the red
light located on the right side of the closing bar is not illuminated.
The machine is now set up correctly. Depressing the foot pedal will operate only one perforation
cycle. This is to ensure that there is no double punching.
The machine can be equipped with a range of punching tools for Wire-O
®
, plastic comb, spiral, and
other binding systems. Further information is available on request.
The changeover of the tools requires no more than 2 minutes.
The sound level when operating amounts to : 72 dBa from 1 metre of the source.
A tray is provided to collect confettis when punching, it is fitted underneath the punch tool
(introduction from right side).
To Next Page
Loading...
