8
. PUNCHING PROCEDURE 17
T
The number of SHEETS that can be punched in one bite will vary according to the type of
paper being used. This will normally be a maximum of 25 sheets of 80gsm paper according to
tool version (about 2 to 2.5 mm). The method of punching is as follows :
See NOTE for acetate paper
8.1 Place a pile of work face downwards neatly at one side of the unit, with the binding
edge away from you.
8.2 Take approximately 20 sheets (2 mm) turn sheets text upwards, locate sheets squarely
against the back of the punching slot and locate against lay gauge.
8.3 Operate the foot switch to punch sheets.
Paper ready to be
punched
To Next Page
Loading...
