6
. STARTING UP PROCEDURE 15
6.1 Connect the plug of your machine to mains power supply.
6.2 At the back of the machine, press on the circuit breaker « 1-0 » the LED (see picture
page 16) located on the right side of the closing bar will light up. The circuit breaker is
then in position « 1 ».
6.3 The LED doesn’t light up :
- Check if your mains power is switched on
- Check if the circuit breaker protecting your plug is engaged (distribution
switchboard)
- Check the two fuses (on circuit breaker « 1-0 »).
Circuit breaker
Main plug
To Next Page
Loading...
