9
. UNJAMMING PROCEDURE FOR THE PUNCHING 19
9.1 If the machine jams, set the rocker switch in the backward position and press the foot
pedal once to allow the tool to come back to its high position.
NOTE : this operation allows disengaging pins from the sheets and then to remove
these sheets.
! CAUTION
Rocker switch
9.2 If the motor cuts out due to overload, then switch on again after 30 seconds and repeat
the operation until the punch tool returns to its up position.
NOTE : do not repeat the operation more than 5 times, then call the after sales service.
9.4 Reset the rocker switch to forward position to return to operating mode.
! NOTICE
If a mechanical failure involves a jam of the machine, then it will be necessary to call the
After Sales department.
–
To Next Page
Loading...
