JBL ON TIME 200ID User Manual

GETTING STARTED (SEE QUICK SETUP)
1. Unpack the JBl On Time 20010 unit and all of its contents.
2. Choose the appropriate adapter for iPod and place it into the docking station.
3. Place the iPod into the adapter.
4. Plug the power adapter into the jack marked "15VDC IN.''
5. Plug the adapter into awall outlet.
6. If an additional audio source is used, connect the source to Aux In.
7. Connect the external AM antenna for better reception.
8. Unwind the FM wire antenna; straighten the wire for the best reception.
9. For backup memory settings, install three AAA batteries.
CONTROLS
Setting the Clock
1. Press Menu/Up level at any screen to display Top Menu (may require repeated presses, depending on which menu state the unit
was previously in).
2. Use Up/Down arrows to highlight Clock. Press Enter to confirm.
3. Use Up/Down arrows to highlight 12-hour or 24-hour format. Press Enter to confirm.
4. Use UplOown arrows to set Hour. Press Enter to confirm. Minute field becomes highlighted.
5. Use Up/Down arrows to set Minutes. Press Enter to confirm. AM/PM field becomes highlighted.
6. Use Up/Down arrows to set Day of Week. Press Enter to confirm. The clock is set!
Note: during clock-setting, if there is no user input for 2 seconds, display will return to the Now Playing screen. Press anyone of the Enter, Up/Down arrows, or
Menu/Up Level to return to setting selection.
Base Unit Control
Power
I
~
A,,,m_v_
so
,,,,
I
Preset
6 ..JBL ON TIME 20010 USER GUIDE
Navigation
SeloctUp
I
--,,",-·0- ,,,,,
I
Select Down
,,"·,·tit¢ SNOOZE J jtJ,.,",

JBL ON TIME 200ID Specifications

General

Brand	JBL
Model	ON TIME 200ID
Category	Docking Station
Language	English