03 - Attachments, Couplings and Load Handling
03 - Direct-Mounted Attachments
00 - General
03 - 8 9813/6050-2 03 - 8
Remove and Install
WARNING If two people are doing this job make
sure that the person working the controls is a
competent operator. If the wrong control lever is
moved, or if the controls are moved violently, the
other person could be killed or injured.
Install
1. Keep the attachment on level ground. Refer to
Figure 5.
Figure 5.
A Attachment frame
B Lip of the frame
2. Drive the machine squarely up to the attachment
frame.
3. Lower the lift arm.
4. Tilt the quickhitch plate forwards.
5. Make sure that the top of the quickhitch plate is
lower than the lip of the attachment frame.
6. Drive the machine until it touches the attachment
frame.
7. Slowly tilt the plate backwards until it engages
the attachment frame lip.
8. Raise the lift arm until the frame is in contact with
the quickhitch plate, top and bottom.
9. Push the quickhitch levers fully inwards, to
engage the locking pins and secure the
attachment frame.
Figure 6.
C Quickhitch lever
D Locking pins
Remove
1. The removal procedure is the opposite of the
installation procedure.
To Next Page
Loading...
