03 - Attachments, Couplings and Load Handling
10 - Excavator End Quickhitch
00 - General
03 - 16 9813/6050-2 03 - 16
Health and Safety
WARNING Do not lean out of the cab to operate
the quickhitch levers. If the controls are moved
accidentally you could be killed or injured.
WARNING Always install the quickhitch latch
hook locking pin (mechanical only). Failure to
install the pin will result in possible failure of the
latching mechanism. Such a failure could result
in the sudden release of an attachment from the
machine and you or others could be killed or
seriously injured.
WARNING The attachment will move when
released. Stand clear and to one side when
releasing the attachment.
WARNING Attachments that are installed with the
use of loader or excavator quickhitches must not
be used to transport or lift persons if the machine
is not designed and equipped to do so.
CAUTION When the quickhitch is attached to the
machine, allowance must be made for the weight
of the quickhitch on the rated operating load. The
mass of the Quickhitch is stamped on the data
plate.
Check (Condition)
1. Check the condition of the quickhitch for
damaged or missing parts.
2. Remove any debris from the latch hook locking
mechanism.
3. When you clean the quickhitch with HP (High
Pressure) water, make sure you grease the latch
hook pivot pin after cleaning.
4. Grease the latch hook pivot pin at the specified
duration
Duration: 7 d
To Next Page
Loading...
