jcb 535-140 Hi Viz - Functional Test and Final Inspection

Section 3-2 - Routine Maintenance
Service Schedules - Machines with SD and SF Engines
Functional Test and Final Inspection
3-2-7 3-2-7
9803/3750-05 (3-20-00)
Functional Test and Final Inspection
Operation 10 50
100
(1)
500 1000 2000 6000
ENGINE
Idle Speed
(2)
- Check and Adjust

Torque Converter Stall Speed
(2)
- Check

Max. No-Load Speed
(2)
- Check and Adjust

Exhaust Smoke - Check

Exhaust System Security
(2)
- Check

Air Inlet System Security - Check

Throttle System and Control Cable
(2)
- Check

Engine for Vibration/Noise
TRANSMISSION, AXLES AND STEERING
Steering - Operation/Phasing - Check

2WD/4WD Selection (if fitted) - Check

Transmission Operation - Check

Forward/Reverse/Gear - Selection/
Operation
- Check

Torque Converter Main Line Pressure
(2)
- Check

Neutral Start Operation - Check

Clutch Disconnect/Dump Pedal/Button - Check

HYDRAULICS
MRV Pressure at Max RPM
(2)
- Check and Adjust

Operation of All Services - Check

Hose Burst Protection Valves (if fitted) - Check

ARV Pressure at 750 RPM
(2)
- Check and Adjust

Steer Circuit MRV Pressure
(2)
- Check and Adjust

Fan Motor Speed (If fitted)
(2)
- Check

Attachment Operation/Remote Servo (if
fitted)
- Check

Piston Rods Chrome - Check

Boom Extension/Phasing (3 stage boom)
(2)
- Check

Parallel Lift/Lower - Check

Stabilizer Leg Cut-out (if fitted)
(2)
- Check

ProCarManuals.com