jcm-tech RB3 T868 - Programming Mode 1: IN1 to R1; Mode 1 Programming Sequence

Mode 1: Safety edge connected to IN1 activates R1
Safety edge connected in IN1 will activate R1.
Employed receiver memory = 1 transmitter
Programming sequence:
•Press PROG button on the receiver (1) until R1 LED lights (2).
•Press PROG button on the transmitter (3).
•A beep will be heard on the receiver indicating the transmitter is properly pro-
grammed (4).
•To exit programming mode, wait for 20 seconds or press PROG button on the
receiver. Two beeps will be heard.
jcmtechnologies
16