JDSU ORL-55 19
4 B
ASIC FUNCTIONS
The following table gives a short overview of the menu
items. These are explained in the sections below.
Wavelengths (Power Meter)
The wavelength table (-Table) supports the definition of
up to 30 wavelengths. The wavelengths with the attribute
“shown” form a set of wavelengths which will be rotated
through when the [] key is pressed.
The remaining wavelengths are “hidden”.
E.g. if only two wavelengths have the attibute “shown”,
you can toggle between them with a single stroke.
To edit the -table:
1. Press Edit -Table in the CONFIGURATION menu.
The EDIT -TABLE menu opens .
Edit -Table Edit the wavelengths in the table
and the view status (show/hide) of
each entry.
Select Auto- Activate/deactivate the “Automatic
Wavelength Detection”.
Edit Contrast Adjust display contrast.
Set Factory
Default
Set the device parameters and
settings to their default values as
defined by JDSU. This does not
affect any stored measurement
results.
Show Info Display basic device information.
Edit Date Adjust date.
Edit Time Adjust time.
Firmware
Update
Download the current device
firmware version from the internet
to the device.
Select
Language
Select the language of the device
texts.
To Next Page
Loading...
Need help?
General
