JDS Uniphase ORL-55 Series - Setting factory default values

22 ORL-55 JDSU
4 B
ASIC FUNCTIONS
– or –
Select DISABLE to switch off Auto-
3. Press [MENU ENTER] to confirm the setting.
If Auto
 mode is activated and a laser source
supporting Auto-
 is connected  Auto-  will be
displayed in the bottom center display pane.
Display in Auto- mode
When Auto- mode is activated and different
wavelengths are detected, the power levels measured at
these wavelengths are displayed simultaneously.
Fig. 7 Display in Auto- mode showing the detected wave-
lengths and their power levels.
Setting the display contrast
1. Select Edit Contrast in the CONFIGURATION menu.
The CONTRAST menu opens:
2. Press [] to increase/decrease the contrast.
3. Press [MENU ENTER] to store the value and exit from
the menu.
Setting factory default values
1. Select Set Factory default in the CONFIGURATION
menu.