134/154
119635
Index G
QUIT JOYSTICK MODE
Explanatory note regarding the joystick in flashing red
«Ready» LED mode:
When the red «Ready» LED is flashing, this indicates that a malfunction has been detected
in the system. This malfunction may occur when the engine is started or the joystick is
used.
In some cases, this fault may be resolved by completely restarting the system
(Recommence starting procedure set out above).
If after restarting the joystick is still not working, use the engine control lever and bow
thruster manually.
If control lever is not working, apply emergency procedure SAFETY set out in owner's
manual ZF.
Press the button for 1 second.
RAYMARINE version: The auto pilot comes out of "MOTORISED
HELM" mode and goes into STAND-BY mode.
SIMRAD version: The auto pilot comes out of POWER mode and
goes into STAND-BY mode.
The joystick goes into standby.
The «Ready» LED is a steady red.
The system switches automatically to control lever function.
If the lever is not in the neutral position it must be put into neutral
before using.
WARNING
To retake control with the engine control lever, it is essential to disengage the
joystick by pressing the button behind the joystick.
To Next Page
Loading...
