32/154
119635
Index G
LIFTING
WETTED AREA: 64 M²
Note: Measurements are expressed in mm.
PRECAUTION
- Consult the harbourmaster's office to find out the conditions of water use and the
maintenance area for cleaning your vessel.
- It is necessary to seek the advice of your concessionnaire with regard to gel-coat
repairs.
PRECAUTION
- When applying the anti-fouling paint do not paint over the electronic instrument
sensors nor the anodes.
ADVICE - RECOMMENDATION
- When in dry dock check the anode on the propeller shaft line.
- See "Motorisation" chapter.
ADVICE - RECOMMENDATION
- During the refit, check the anodes (See "Motorisation" chapter).
- When the boat is stored at a dry dock, the corrosion protection is not as effective due
to oxidation of the anodes: even the new anodes oxidize the surface. Before returning
the boat into the water, clean the anodes.
- Cleaning anodes: Use sandpaper.
Do not use metal brushes or steel tools to clean the boat, it may damage the galvanic
protection.
- Replacing the anodes: The anodes are fastened with screws and nuts. First, remove
the screws and nuts that hold the anode, then clean the contact surface. Press the
new anode to obtain a good electrical contact
7
270
3
0
0
100
1
0
0
To Next Page
Loading...
