IN CASE OF EMERGENCY 249
4. Remove the bulb from the bulb socket by
pulling the bulb straight out.
Bulb And Socket Assembly
5. Insert the new bulb, making sure that it is
locked into place.
6. Reinstall the socket in to the transparent
lens assembly.
7. Reinstall the cover on the outside rear view
mirror, making sure it is locked into place.
Rear Tail Lamps
Contain the following:
Position lights
Stop lights
Direction indicator
REVERSE lights
To replace the bulbs proceed as follows:
1. Open the liftgate.
2. Using a suitable tool remove the door as
shown.
Trim Panel Door
3. Using a suitable tool remove fastener.
4. Disconnect the electrical connector by
pushing the release.
Rear Lamp Fastener and Electrical Connector
1 — Bulb
2 — Bulb Socket
1 — Electrical Connector
2 — Fastener
6
20_BV_OM_EN_USC_t.book Page 249
To Next Page
Loading...
