To Next Page

To Previous Page

OPERATIONCR271ML

Steering Wheel Controls

We recommend the PAC SWI-RC .

1. Set "Radio Select Switch". Set the SWI-RC to position 7 - "Pioneer/Other/Sony".

2. To program, use the Pioneer/Sony/Other radio function mapping order.

3. When programming the SWI-RC, if a function is not supported (or not desired), then the

function MUST be skipped as per the PAC SWI-RC instructions.

4. The SWC function MUST be programmed in the correct order per the PAC SWI-RC radio

function mapping order instructions.

A third-party adapter must be used in order for the CR271ML to be compatible with any

OEM steering wheel controls.

The CR271ML has a built-in 3.5mm SWC interface that compatible with many popular 3rd

party SWC control modules, such as PAC, METRA, and others.

The following controls are available for most vehicles.

Volume +

Volume -

Mute

Seek / Track +

Seek / Track -

Band

Mode

BT Talk

BT End Call

Note: Not all OE steering wheel functions may be supported by the CR271ML

POWER

MAXIMUM OUTPUT 500mA

YELLOW

BLACK

Replace with

ATO Type fuse

Only

3.5mm SWC port located on the rear of the unit, on the

MAIN POWER I/O Harness

Jensen CR271ML User Manual

Questions and Answers: