What to do if Jensen DMX5020 resets itself when the engine is off?
If your Jensen Car Receiver resets itself when the engine is off, the cause may be an incorrect connection between the ACC and positive battery wire. Check the wiring and correct it.
Why Jensen Car Receiver has no/low audio output?
If your Jensen Car Receiver has no or low audio output, there could be several reasons: * Improper audio output connection: Check the wiring and correct it. * Volume set too low: Increase the volume level. * Improper “MUTE” connection: Review the wiring diagram and check the “MUTE” connection. * Damaged speakers: Replace the speakers. * Heavily biased volume balance: Adjust the channel balance to the center position. * Speaker wiring in contact with the car's metal: Insulate all speaker wiring connections.
What to do if Jensen DMX5020 Car Receiver unit will not power on?
If your Jensen Car Receiver unit will not power on, here are a few things to check: * Radio Fuse: Install a new fuse with the correct rating. * Car battery fuse: Install a new fuse with the correct rating. * Illegal operation: Press the RESET button located in the middle of the left side of the front panel.
Why Jensen DMX5020 Car Receiver has weak station searching?
If your Jensen Car Receiver is showing weak station searching, the reasons may be: * Auto antenna is not fully extended: Extend the antenna fully or connect the auto antenna control cable properly. * Auto antenna not properly connected: Connect the auto antenna control cable properly. * LOCAL function is activated: Turn the LOCAL function off.
What to do if Jensen DMX5020 has poor sound quality or distortion?
If your Jensen Car Receiver has poor sound quality or distortion, it could be due to: * Speaker power rating not compatible with unit: Connect proper speakers. * Speaker is shorted: Check speaker contact.
What to do if Jensen DMX5020 has no image?
If your Jensen Car Receiver shows no image, check the following: * Incorrect connection to parking brake wire: Check wiring and correct. * Parking brake is not engaged: Stop vehicle in a safe place and apply parking brake.
Why flashing image or interference appears on screen of Jensen DMX5020 Car Receiver?
If a flashing image or interference appears on the screen of your Jensen Car Receiver, it might be due to improper video signal connections. Check the wiring and correct it.
Why prolonged image or improper height/ width ratio display on Jensen DMX5020?
If you observe a prolonged image or an improper height/width ratio display on your Jensen Car Receiver, it's likely due to an improper aspect ratio setup. Use the correct aspect ratio setting.
What to do if interruption occurred during playback on Jensen Car Receiver?
If an interruption occurred during playback on your Jensen Car Receiver, it could be due to a damaged file or bad recording. Reinstall files on the USB device or microSD card.
General| Brand | Jensen |
|---|---|
| Model | DMX5020 |
| Category | Car Receiver |
| Language | English |
Compliance with FCC radiation exposure limits for uncontrolled environments.
How to connect and use iPod/iPhone for music and video.
Hands-free operation and audio streaming via Bluetooth.
Warnings regarding installation, operation, moisture, and fuse use.
Description of LCD screen, remote sensor, AV IN, and microSD slot.
How to connect devices like game consoles, camcorders, iPods via AV-IN.
Instructions for powering the unit on and off using front panel controls.
Steps to navigate the menu and select sources like Radio, USB, BT, Pandora.
How to enter the SETTINGS MENU and adjust features.
Adjusting audio settings like presets, balance, fade, and loudness.
Procedures for soft and hard resets to restore factory settings.
Customizing EQ presets, frequency bands, balance, and fade.
Connecting and accessing iPod/iPhone via USB for control.
Overview of Bluetooth, its capabilities, and mobile phone requirements.
How the unit handles incoming calls and displays caller information.
Direct dialing, answering, rejecting calls, and volume control.
Establishing connection via HFP and pairing the mobile phone with the unit.
Steps to program custom steering wheel controls.
Overview of the Pandora screen, artist, song, and album display.
Solutions for power issues, no/low audio, and poor sound quality.
Solutions for TFT monitor, tuner, and MP3 playback problems.
Electrical specs, operating temp, fuse, dimensions, and power output.
To Next Page
