Why does my Jensen Car Receiver keep resetting when the engine is off?
If your Jensen Car Receiver is resetting itself when the engine is off, it is likely due to an incorrect connection between the ACC and the positive battery wire. You should check the wiring and correct it to resolve this issue.
How to fix a Jensen Car Receiver that will not power on?
If your Jensen Car Receiver unit fails to power on, it could be due to a blown radio fuse. Replace the fuse with a new one that has the correct rating. Another possible cause is a blown car battery fuse, which also requires replacement with a fuse of the correct rating. In some cases, the unit may not power on due to an illegal operation. If this is the case, try pressing the RESET button located in the bottom right corner of the front panel.
What to do if my Jensen DVDB01 Car Receiver remote control does not function?
If your Jensen Car Receiver remote control isn't working, the first thing to check is the battery. If the battery is depleted, replace it with a new one. If that doesn't solve the problem, make sure the battery is installed correctly by removing it and reinstalling it properly.
Why does my Jensen DVDB01 disc not play back?
If your Jensen Car Receiver disc does not play back, it could be due to several reasons. The disc might be warped or scratched, in which case you should use a disc in good condition. Alternatively, the disc could be dirty or wet, so try cleaning it with a soft cloth. Another possibility is that the laser pickup is dirty, requiring cleaning with a cleaning disc. Ensure that you are using a compatible disc with the proper region code and that the disc is inserted with the label side up.
Why is there no repeat or searching while playing VCD on my Jensen Car Receiver?
If repeat or searching functions are not working while playing a VCD on your Jensen Car Receiver, it is likely because PBC (Playback Control) is turned on. Turn PBC off to enable these functions.
Outlines essential safety and operational guidelines for using the DVDB01.
Instructions on how to safely disconnect the vehicle's battery before installation.
Step-by-step guide for installing the unit using the DIN front-mount method.
Instructions for installing the unit using the DIN rear-mount method.
Steps to reconnect the vehicle battery after completing wiring and installation.
Detailed steps for safely removing the DVDB01 unit from the dashboard.
Details the wiring connections for power and accessories for the DVDB01.
Identifies and describes the buttons and indicators on the front panel of the unit.
Details the buttons and their functions on the remote control for the DVDB01.
Instructions for resetting the unit to its default settings.
Adjusting TV System, Screen Saver, TV Type, Password, Rating, and Default settings.
Configuring OSD, Audio, Subtitle, and Menu languages for DVD playback.
General| Brand | Jensen |
|---|---|
| Model | DVDB01 |
| Category | Car Receiver |
| Type | DVD Receiver |
| Display Type | LCD |
| Screen Size | 7 inches |
| Resolution | 800 x 480 |
| Touchscreen | Yes |
| Built-in DVD Player | Yes |
| AM/FM Tuner | Yes |
| USB Port | Yes |
| Auxiliary Input | Yes |
| Bluetooth | Yes |
| Remote Control | Yes |
| Power Output | 200 Watts |
| Supported Formats | DVD, CD, MP3, WMA |
| SD Card Slot | Yes |
| RCA Outputs | Yes |
| Peak Output | 50 watts |
| RMS Power Output | 20 watts |
To Next Page