E-3
COMPLIANCE WITH FCC REGULATIONS
FCC ID RQU-TT-933BPC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
PROTECT YOUR FURNITURE
This system is equipped with non-skid rubber ‘feet’ to prevent the product from moving
when
you
operate the controls. These ‘feet’ are made from non-migrating rubber
material specially
formulated
to avoid leaving any marks or stains on your furniture.
However certain types of oil based
furniture
polishes, wood preservatives, or cleaning
sprays may cause the rubber ‘feet’ to soften, and
leave
marks or a rubber residue on
the
furniture.
To prevent any damage to your furniture we strongly recommend that you
purchase small
self-
adhesive felt pads, available at hardware stores and home
improvement centers everywhere,
and
apply these pads to the bottom of the rubber
‘feet’ before you place the product on fine
wooden furniture.
To Next Page
Loading...
Need help?
General
