7
VM9224
OPERATING INSTRUCTIONS
Power On / Off
Press the /SRC button (4) on the unit to turn the unit on.
The buttons on the front of the unit light up and the current mode status
appears in the LCD (7).
Press and hold the button to power off the unit.
Audible Beep Confirmation
An audible beep tone confirms each function selection. The Beep tone can be
disabled through the Setup menu.
Mute/Line Mute
Press the rotary encoder button (7) on the front panel to mute the volume
from the unit. Press the rotary encoder button again to restore the volume.
“MUTE” is displayed on the LCD. Adjusting the volume or using any of
the audio setup features cancels the mute function.
If the “MUTE” wire is connected, audio output mutes when a telephone call is
received by the car phone (using optional BTM10) or when verbal navigation is
performed (using optional NAV102).
Playing Source Selection
When the monitor is closed, press the SRC button on the front panel (4)
to change between available audio playing sources in the
following order: RADIO, DISC, USB1, USB2, SD, BT, NAV, AUX and
CAMERA.
Source Menu
You can also use the touch screen to change the source through the SOURCE
MENU. To access the SOURCE MENU, touch the top left corner of the screen
or press the SRC button on the front panel (4) .
SOURCE MENU
RADIO
RADIO
BT
DISC
NAV
USB1
AUX
USB2 SD
CAMERA
N
S
E
W
8GB
Downloaded from Caradio-Manual.com Manuals
To Next Page
Loading...
Need help?
General
