Jensen VX3010 - Basic Unit Operations; Mute and Volume Adjustment; TFT Monitor Usage; System Reset Procedures

VX3010
Mute
Press
the
volume
knob
on
the
front
panel
or
press
the
[MUTE] Button on
the
remote
control
to
mute the
volume
from the unit.
Volume
Adjustment
Volume Increase/Decrease
To
increase or decrease
the
volume
level,
turn
the
rotary encoder on the
front
panel.
When the
volume level
reaches
"0"
or
"50",
a beep sounds, indicating
that
the adjustment limit
has
been reached. The
TFT
screen
displays
the
volume level
for 3 seconds.
Audible
Beep
Confirmation
An
audible beep tone confirms each function
selection.
The
beep tone
can
be
disabled
through the Setup menu.
Using
the TFT
Monitor
Open
I Close
monitor
Press
the
[OPEN]
Button on the front
panel
or remote control
to open or
close
the
display panel.
NOTE:
Never
manualy
open
or
close the display panel.
Change the
monitor
tilt
angle
Due
to
the
inherent character
of
LCD,
you
will
get
different vision impressions
when you watch
it
from different
angles.
The
display angle
of
this
unit
can be
changed; hence you
can
select
the best angle
where you
can
get the best vision
impression.
Press
and
hold
the
[OPEN]
Button
to
enter
display angle
setting mode,
and rotate the knob
to
adjust.
NOTE:
Never
manually
tilt
the display panel.
Resetting
the
System
Soft Reset-
To
correct a system
halt
or other
illegal
operation,
use
the
tip
of
a pen
to
press and
release
the reset
button
located
just
below
the front panel control
knob.
~[RESET]
Button
Figure 5. System Reset
Button
For
a Hard
Reset-
Touch the System
Reset
Icon
on the Third Settings Screen.
After a system reset, the unit restores all
factory
default
settings.
NOTE:
If
the
unit
is
reset while a DVD
is
playing, the
unit
will
return
to
Main Menu
once the reset
is
complete.
16