Jensen VX3014 User Manual (English)

Other manuals for Jensen VX3014

Operation Manual45 pages

Installation & Quick Start Guide4 pages

Questions and Answers:

M
Miranda PerkinsJul 26, 2025
Why is there no audio output from my Jensen Receiver?
- C
  clarkejeffreyJul 26, 2025
  There could be several reasons for the lack of audio output from your Jensen Receiver: * The audio output connection might be improper; in this case, check the wiring and correct it. * The volume might be set too low; increase the volume level. * The speakers could be damaged; consider replacing them. * The volume balance might be heavily biased; adjust the channel balance to the center position. * The speaker wiring might be in contact with the metal part of the car; insulate all speaker wiring connections.
B
Brittany MitchellJul 30, 2025
What to do if my Jensen Receiver unit cannot power on?
- T
  Thomas SmithJul 30, 2025
  If your Jensen Receiver unit cannot power on, it might be due to a blown fuse. Check both the unit fuse and the car battery fuse, and install a new fuse with the correct rating if either is blown. Also, in case of illegal operation, try resetting the unit.
L
logancherylAug 3, 2025
Why is the sound quality poor or distorted on my Jensen Receiver?
- D
  Daniel ParkerAug 4, 2025
  Poor sound quality or distortion on your Jensen Receiver can occur due to several reasons: * If you are using a pirate disc, switch to an original disc. * If the speaker power rating does not match the unit, replace the speakers. * Check the wiring for wrong connections and correct them. * Also, the speaker may be shorted, so check the wiring and correct it.
Z
zevansAug 8, 2025
What to do if the remote control for my Jensen Receiver does not work?
- D
  Dylan OrtizAug 8, 2025
  If the remote control for your Jensen Receiver is not working, the battery may be depleted. Try changing the battery. Also, ensure that the battery is installed correctly.
R
robinalexanderAug 12, 2025
Why does my Jensen Receiver unit reset itself when the engine is off?
- G
  Gary WilsonAug 12, 2025
  If your Jensen Receiver unit resets itself when the engine is off, it is likely due to an incorrect connection between the ACC and BATT. Check the wiring and correct it.
B
bhumphreyAug 17, 2025
Why is flashing image or interference appearing on my Jensen Receiver screen?
- J
  Jared ChambersAug 17, 2025
  A flashing image or interference on your Jensen Receiver screen may be caused by: * Using a pirate disc; in this case, use an original disc. * A damaged video cable; replace the cables. * Improper video signal connections; check the wiring and correct it.
J
Joshua NelsonAug 21, 2025
How to fix warning information shown at all times on Jensen Receiver?
- L
  Lauren RamirezAug 21, 2025
  If warning information is constantly displayed on your Jensen Receiver, the parking brake wiring is likely incorrect. Check the wiring and correct it.