EasyManuals Logo
Home>Jerr-Dan>Construction Equipment>MPL-NG

Jerr-Dan MPL-NG User Manual

Default Icon
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Section 1 - General Safety Practices
1-6 5376000275
UNCONTROLLED TOWED LOAD HAZARDS
DO NOT exceed GAWR’s or GCWR of the chassis.
Set parking brake and chock wheels of the recovery vehicle when connecting
casualty vehicle.
Use two (2) safety chains and two (2) tie-down chains or straps.
Release parking brake of casualty vehicle prior to moving.
Check chain tension periodically while in transit.
Always retract underlift as close as possible. Leave enough room to maneuver
around corners without corner binding or causing contact between the two (2)
vehicles.
Ensure safety chains are properly attached from recovery vehicle to casualty
vehicle.
Attach auxiliary D.O.T. towing lights to the casualty vehicle.
When towing a vehicle from the front or rear, ensure vehicle steering wheel is
properly locked.
Tow casualty vehicle on undamaged wheels/tires only.
Retighten the tie-down straps during a tow as the tires settle into the grid from
towing.
TIP-OVER HAZARDS
Set up on rm surface only.
Ensure truck is level prior to any boom operations.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jerr-Dan MPL-NG and is the answer not in the manual?

Jerr-Dan MPL-NG Specifications

General IconGeneral
BrandJerr-Dan
ModelMPL-NG
CategoryConstruction Equipment
LanguageEnglish