EasyManua.ls Logo

Jerr-Dan MPL-NG - Winch Functioning Improperly

Default Icon
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 6 - Maintenance
5376000253 6-17
HYDRAULIC PUMP
Problem Cause Solution
Oil foaming a. Air leaking into suction line
b. Wrong kind of oil
c. Oil level too low
a. Tighten all connections
b. Drain and rell with
non-foaming type of hydraulic
oil (See lube chart)
Replace lter
c. Rell to proper level
Hydraulic oil leak
between P.T.O. and
pump
a. Defective shaft seal a. Replace shaft seal
Pump leaks at front
and rear covers
a. Defective seals a. Replace seals
WINCH FUNCTIONING IMPROPERLY
Problem Cause Solution
Winch screeches
during operation
a. Insu󰀩cient lubrication a. Lubricate per lube chart
Winch will not pull load
or take in wire rope
a. Free-spooling device
not engaged
b. Sheared keys or broken
coupling
c. Hydraulic pump worn
a. Engage
b. Inspect or replace
c. Inspect and replace

Table of Contents