Section II: Operation
Page 20
5-376-000086
REV. 4 - 07/10
4. Engage the Power-Take-Off
(PTO) or Clutch Pump and the
hand controller using the “Control”
switch in the switch panel. Most
trucks will automatically throttle
up when the parking brake is set
and the transmission is park or
neutral. NEVER TRAVEL WITH
THE POWER-TAKE-OFF or
CLUTCH PUMP CONTROL
ENGAGED. This could result in
damage to the PTO or Clutch
Pump unit and the truck
transmission.
CAUTION:
Never exceed 1,500 R.P.M. When your hook up is complete, reset
the engine idle to normal.
5. Confirm the truck’s position in
relation to the vehicle to be towed.
Nine (9) feet is recommended.
Reposition the MPL40 if
necessary. Be sure the towed
vehicle is not in gear or park.
Keep the brake set.
9 FT
To Next Page
Loading...
Need help?
General