Section II: Operation
Page 21
5-376-000086
REV. 4 - 07/10
6. Using the hand controller or
manual controls located at the
rear of the body, unfold the
underlift using the tilt down
function. The underlift level stop
assist system will stop the
underlift travel at a preset position.
7. Next, lower the underlift using the
underlift down funtion on the hand
controller. The underlift level stop
assist system will stop the
underlift travel at a preset position
about 1-1/2" to 2” from the ground.
NOTE:
To override either stop
position, simply release the
control function and
reactivate the same control
function again to achieve
further travel of the underlift.
To Next Page
Loading...