EasyManuals Logo

Jerr-Dan MPL40 User Manual

Jerr-Dan MPL40
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
Section II: Operation
Page 61
5-376-000086
REV. 4 - 07/10
9. Push the motorcycle up the ramp
until the front wheel is resting in
and against the tire stops in the
front brackets.
10. Check front tire for fit with the
upper and lower tire stops. When
the motorcycle is rocked side to
side the front tire should feel solid
in the tire stops and centered in
the trough. If the front tire is not
clamped in the stops, back the
motorcycle off and readjust the
stops as necessary.
11. With the motorcycle stable in the
towing adapter, strap the front tire
to the wheel lift boom. Place the
hooks of the “middle” wheel
straps over the end of the boom
top plate and run the other ends
of the straps thru the front tire.
Insert the lose end of the wheel
strap into the ratchet on the end
other strap and tighten.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jerr-Dan MPL40 and is the answer not in the manual?

Jerr-Dan MPL40 Specifications

General IconGeneral
BrandJerr-Dan
ModelMPL40
CategoryUtility Vehicle
LanguageEnglish