EasyManuals Logo

Jerr-Dan MPL40 User Manual

Jerr-Dan MPL40
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
Section II: Operation
Page 62
5-376-000086
REV. 4 - 07/10
12. After securing the front tire,
extend the wheel lift under the
rear tire of the motorcycle raising
the rear tire of the motorcycle onto
the ramp.
13.Tie down the rear of the
motorcycle. Place the hook on
one end of the “rear” strap into
the hole on the front side of the
grid. Place the other hook onto
the motorcycle and tighten.
Repeat for the other side.
14. Raise the underlift boom to the
desired towing height.
CAUTION:
Care should be taken when lifting
the boom. Do not try to level the
underlift. The straps may
overtighten or become loose.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jerr-Dan MPL40 and is the answer not in the manual?

Jerr-Dan MPL40 Specifications

General IconGeneral
BrandJerr-Dan
ModelMPL40
CategoryUtility Vehicle
LanguageEnglish