Operating manual Page 13
10. Service and Maintenance
Disconnect mains prior to any service and maintenance work!
The welding unit is, on principle, maintenance-free. However, make it a rule to carry out the following work:
Clean current contact tip and gas nozzle regularly, removing welding spatter and other impurities. Add Anti-Stick
agent on nozzles after cleaning to reduce undesirable spatter adhesion.
Check current contact tip regularly for wear or damage, replace in time.
Clean the welding unit by air-blasting from inside according to pollution level.
Attention:
This Welding unit has to be safety checked every year by Fa. Jäckle & Ess System GmbH or another special
qualified electrician according to the harmonized standard
IEC 60974 – 4
Safety, maintenance and inspection of arc welding equipment in use
To Next Page
Loading...
