Program Mode Jester Operating Manual
Jester Manual 73-403-00 Issue 3.2 19 of 52
Copying a Chase Step
1. Use the cursor buttons to select a programmed chase memory or press the
channel flash button under the submaster.
2. Press the cursor right button.
3. Use the cursor buttons to select the step to be copied.
4. Press the COPY/PASTE button. The contents of the chase step will be stored
internally. The light in the COPY/PASTE button will be illuminated.
Copying a Submaster
1. Use the channel flash buttons to select a programmed submaster.
2. Press the COPY/PASTE button. The contents of the submaster will be stored
internally. The light in the COPY/PASTE button will be illuminated.
Pasting into a Scene Memory
1. Copy the required memory data (from a scene memory or chase step) as
described above. Ensure that the light in the COPY/PASTE button is on.
2. Use the cursor buttons to select a scene memory.
3. Press and hold SHIFT and press the COPY/PASTE button. The memory data
copied will be pasted into the scene memory.
Pasting into a Chase Step
1. Copy the required memory data (from a scene memory or chase step) as
described above. Ensure that the light in the COPY/PASTE button is on.
2. Use the cursor buttons to select a chase memory.
3. Press the right cursor button.
4. Use the cursor buttons to select the step into which the data is to be pasted.
5. Press and hold SHIFT whilst pressing the COPY/PASTE button. The memory
data copied will be pasted into the chase step.
Pasting into a Submaster
1. Copy the required memory data (from a scene memory or chase step) as
described above. Ensure that the light in the COPY/PASTE button is on.
2. Use the submaster buttons to select a submaster.
3. Press and hold SHIFT and press the COPY/PASTE button. The memory data
copied will be pasted into the submaster.
To Next Page
Loading...
Need help?
General