Jet-tech X-35C - Troubleshooting; Machine Wont Shut Off; Machine Wont Fill; Spray Arms Wont Spin

15
Phone:
1-888-275-4538
514-737-9701
Fax:
514-737-2792
MODEL: X-35C
SERIAL:________________
DATE INSTALLED:___/___/___
SERVICE:
_______________________
_______________________
CHEMICALS:
_______________________
_______________________
IMPORTANT NOTES
Locate and clearly identify the water shut-off valve that supplies the dishwasher and the
fuse box or breaker switches.
Only qualified and/or licensed technicians can repair this piece of equipment. Removing
panels will expose wires and live current. The breaker switch should be switched off or fuses
removed before removing the panels. The water supply must also be turned off.
CONTACT INFORMATION
H. Machine Won't Shut Off
1. You can turn off the machine in an emergency by turning off the master switch
located at the back of the control box.
I. Machine Won't Fill
1. Check valve at the top, make sure handle is turned on. If it is, call us the Jet-Tech
service people.
J. Spray Arms Won't Spin
1. Check the bearings for obstructions. They are easily clogged by grit, string from tea
bags, or fiber from napkins or straw wrappers.
K. Dishes Are Coming Out Soapy
1. Make sure water temperature is above 120 degrees F; hot water disperses suds.
2. Determine that machine is draining properly so that no soapy water carries into the
rinse.
3. Make sure that no other source of detergent is finding its' way into the rinse cycle.