16
10.2 Operational problems
Symptom Possible Cause Correction
Cuts not square. Blade not square to vise/material. Adjust vise square to blade.
Blade surface not perpendicular to
table.
Adjust blade guides until perpendicular.
Workpiece shifting in vise. Properly secure workpiece.
Low blade tension. Increase tension.
Blade guides out of adjustment. Adjust blade guides.
Premature dulling of
blade teeth
Improper blade break-in. Follow proper break-in procedure.
Excessive blade speed, blade teeth
overheating.
Decrease speed.
Improper tooth pitch for material. Use proper blade.
Rough cut. Improper blade break-in. Follow proper break-in procedure.
Improper speed or feed rate. Adjust as needed.
Dull or damaged teeth. Replace blade.
Poor weld on blade. Replace or re-weld blade.
11.0 Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-
274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial Number of
your machine available when you call will allow us to serve you quickly and accurately.
Some parts are shown for reference only, and may not be available individually.
Non-proprietary parts, such as fasteners, can usually be found at local hardware stores or may be ordered from
JET.
To Next Page
Loading...
Need help?
General
